User guide

ManualsBrandsBrandmotion ManualsCar9002-8501

INSTALLA TION(INSTR UCT IONS (

8501 Instructions 7-18-13.doc Page 1 of 4

OEM Lip Mount CCD Camera with Harness

(Kit part number 9002-8501)

Please read thoroughly before starting installation

and check that kit contents are complete.

Items Included in the Kit:

Tools & Supplies Required:

Bubble bag containing:

Camera with Mount (in zip lock bag)

Camera Harness

Chassis Harness

Zip lock bag containing:

2 Rubber Well Nuts

2 Bolts

Zip lock bag containing:

These Instructions

Self-adhesive Template

Phillips Screwdriver

Center Punch

1/8” & 5/16” Drill Bits

5/8” Drill Bit or Center Hole Saw

Power Drill

Deburring Tool or Round File

Multi-meter or computer safe test light

Wire Ties or Electrical Tape

Wire Crimper

Ground Eyelet

(Recommended)

Rust Inhibitor

(Recommended)

Soldering Iron (Recommended)

Solder

(Recommended) or T-taps

Plastic Trim Removal Tool

Vehicle service manual

(If needed)

Safety Precautions:

• Work in a well ventilated area that is clear of obstructions.

• Secure vehicle with tire chucks in both front and rear of tires.

• Turn vehicle accessories OFF and ensure ignition key is in OFF position.

• Wear safety goggles and snug fitting clothes.

• Use tools only for their intended purpose and which are in good repair.

• Only perform this task if confidence, skill, and physical ability permit.

NOTE: We strive to provide accurate and up-to-date installation instructions.

For the latest full color instructions, as well as an installation video (refer to relevant portions of the video

for Kit # 9002-8530), please visit www.brandmotion.com

Step 1: Place Camera Mount in desired position to

confirm fitment. (IMPORTANT: Some states

prohibit items blocking the vehicle license plate;

check local authorities to confirm legal status for

your specific application).

Step 2: Peel adhesive backing from supplied

Camera Mount Template and apply to the desired

location making sure that the camera direction is

correct.

NOTE: If self-adhesive Template is missing or

damaged, cut out the image above and affix

with Masking Tape.

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS OEM Lip Mount CCD Camera with Harness (Kit part number 9002-8501) Please read thoroughly before starting installation and check that kit contents are complete.
PAGE 2
INSTALLATION INSTRUCTIONS Step 3: Use a Center Punch to mark the centers of the required three holes and drill three pilot holes using a 1/8” drill bit. NOTE: If your vehicle has a liftgate panel/trunk trim cover, it must be removed. Step 8: Preload the screws into the Camera Harness connector. Step 9: Align the Camera Harness head so the key lines up with the slot in the camera, and plug in the connector.
PAGE 3
INSTALLATION INSTRUCTIONS Step 13: Splice the red and green Chassis Harness leads into the corresponding vehicle wires and the black wire to chassis ground. (Note: Soldering recommended or T-taps as optional connection method). RECOMMENDED: Attach an eyelet to the black ground wire. Step 14: Route Camera Harness towards the side of the vehicle that supplies power. Step 17: Secure Camera Harness to existing vehicle wiring. This will minimize chance of binding or otherwise damaging the harness.
PAGE 4
INSTALLATION INSTRUCTIONS Revision History Date Revision 7/18/13 Added Center Punch to list of tools and supplies required. 8501 Instructions 7-18-13.