Owner's Manual

INSTALLATIO N (IN S TR UCTIONS(
9002-9560 Instructions 9-23-16.doc GS
2 of 7
Preparation
1. Ensure all lamps and accessories are OFF.
2. Ensure the ignition switch is in the OFF position.
3. Loosen the negative battery cable bolt. Remove
negative battery cable from terminal and position
away from battery.
4. Wait one (1) minute prior to working on the vehicle
to assure SIR roof rail airbag system has been
disabled for your safety.
Install Camera Bezel into Tailgate
5. Lower Tailgate and remove center bezel mounting
bolt (1), using 13mm socket. Figure 1.
FIGURE 1
6. Release, by hand, the three retainer clips securing
the bezel (2) to the Tailgate outer panel. Lift the
Tailgate latch handle in order to aid in the removal
of the latch handle bezel. Figure 1.
7. If the Truck is not equipped with Tailgate Lock
(&A60), remove the two upper Tailgate Latch
Handle Bolts (1) from the Tailgate Latch Handle (2),
using 13mm socket. Figure 2. Release Rods before
removing (inset). If equipped, skip this step.
FIGURE 2
8. Prepare a work surface for the Tailgate, as it will be
removed.
9. Disconnect the two Tailgate support cables. Figure
3.
FIGURE 3
10. With the aid of an assistant, remove the Tailgate
and locate to clean work surface. Figure 4.
FIGURE 4
11. Locate the supplied Template Sheet for the Tailgate
and Pickup Box Sill.
Note: For Model Year 2009 and forward, some
vehicles may already have a flanged hole in
the pickup box sill. If this is the case, remove
the flange from the front side of the sill and
skip Steps 13 & 15.
12. Cut out Tailgate Template and attach to Tailgate
using tape. Using the Center Punch, mark the center
of hole.
13. Cut out Sill Plate Template and attach to Pickup Box
Sill using tape. Using the Center Punch, mark the
center of hole.
14. Using a power drill and a 29mm (1-1/8”) Hole Saw,
cut out the harness pass-through in the Tailgate.
Figure 5.
£ ' '
MOTION)
seamless vehicle persona l ization _/
0