Owner's Manual

INSTALLATIO N (IN S TR UCTIONS(

9002-9560 Instructions 9-23-16.doc GS

4 of 7

FIGURE 10

23. Snap the supplied Tailgate Bezel Assembly into the

Tailgate.

24. Seat the second grommet (4) securely around

opening. Figure 10.

25. Install remaining Tailgate Latch Handle Bolt in

Tailgate and tighten all three 13mm bolts to 25 N·m

(18 lb ft).

26. If present, remove the Rear License Plate.

27. With the help of an Assistant, re-install the Tailgate

onto the Pickup Box, carefully routing the Camera

harness through the opening on the Pickup Box Sill.

28. Re-attach Tailgate Support Cables and close

Tailgate. Figure 11.

FIGURE 11

29. Through the License Plate Opening pull the Camera

Assembly Harness (2) until the first grommet (3) is

properly seated in the Pickup Box Sill (1). Figure 12.

FIGURE 12

Determine Reverse Signal Location

30. Using a Trim Removal Tool, remove Left Instrument

Panel Outer Trim Cover (1). Figure 13.

FIGURE 13

31. Remove M-BEC cover under the dashboard by popping

it off with hands. Figure 14.

FIGURE 14

32. Have an assistant set parking brake, start vehicle,

and shift into Reverse. Using a digital multimeter,

check for Reverse signal in Cavity 5 at the Light

Gray C11/X11 Connector OR Cavity 8 of Gray C10/

X10 Connector in the M-BEC. Figures 15, 16, and 17.

£ ' '

MOTION)

seamless

vehicle

persona

ization

---