Owner's Manual

INSTALLATIO N (IN S TR UCTIONS(

9002-9560 Instructions 9-23-16.doc GS

5 of 7

FIGURE 15

FIGURE 16

FIGURE 17

33. If Reverse signal is NOT present in the C10/ X10

Connector or C11/ X11 Connector:

A. Check that bail that secures the M-BEC

connectors is fully locked. Repeat Step 33.

B. If Reverse signal is still not present, check Fuse

Block for any blown fuses. Figure 15. Replace

any blown fuses and repeat Step 33.

C. If Reverse signal is still NOT present,

connection to Reverse signal must be made at

the BCM rather than the C10/ X10 or C11/ X11

Connector (refer to Step 50 under “Install

Chassis Harness & Connect to Aftermarket/ NAV

Display”).

Cut Accessory Pass-Through in Front of

Dash

34. Remove Parking Brake Release Handle Bolt and the

Handle. Remove two Knee Bolster Assembly Screws

(1) and Knee Bolster Assembly (2). Figure 18.

FIGURE 18

35. Disconnect the electrical connections, if applicable.

36. Disengage the M-BEC (1) from support bracket.

Figure 19.

FIGURE 19

£ ' '

MOTION)

seamless

vehicle

persona

ization

PA-

--::-..