Owner manual

9618 Instructions 7-1-13.doc Page 1 of 2
9002-9618 Installation Instructions (Slimline Auto Dimming
Twist-off Mount Video Display Mirror)
IMPORTANT: Check kit contents and read instructions before installing. For the latest full color instructions
please visit www.brandmotion.com.
Kit contents: Slimline Auto Dimming Mirror with 3.5” Video Display
Mirror Harness
These instructions
Mirror Removal & Mounting
1. Remove the existing vehicle mirror by twisting it approximately 30 degrees.
2. Carefully twist on the supplied Mirror approximately 30 degrees until it clicks into place.
3. Connect supplied Mirror Harness to supplied Mirror.
Mirror Wiring
1. Brandmotion provides Red (Ignition),
Green (Reverse), and Black (Ground)
wires at both the mirror connector end
and the RCA end of the supplied Mirror
Harness. The three wires at the mirror
connector end are included because some
vehicles have Ignition and Reverse signals
as well as Ground available at the existing
rear view mirror harness making it
possible to splice into the existing vehicle
harness.
If this is not the case for your
vehicle, use the three wires at the RCA
connector end to connect to vehicle
Ignition and Reverse signals and Ground.
Typical locations are behind the driver or
passenger side kick panel or under dash.
2. Use a multimeter to test for vehicle Igniton (+) and Reverse (+) signals. Set parking brake,
start vehicle, and have an assistant shift into Reverse while you test for Ignition and Reverse
signals.
3. Route Mirror Harness beneath headliner and down the A-pillar closest to the Ignition and
Reverse signal locations.
4. Splice Mirror Harness wires to the following required connections:
Red - Ignition controlled power 12v+ when key is ON
Green - Connect to Reverse (+) power (backup lamps)
Black - Chassis ground. A ground bolt is commonly found in the front kick panel area with
other wires attached; in some cases you may need to supply a new screw.
5. Connect female RCA plug on supplied Mirror Harness to male camera RCA.
Mirror & Mirror Harness Pinouts
MIRROR
HARNESS
WIRE COLOR
MIRROR
WIRE
COLOR
FUNCTION
White
Pin 1
Purple
Pin 1
Video (+)
Connects to RCA
Brown
Pin 2
White
Pin 2
Video (–)
Connects to RCA
Red
Pin 6
Red/Blue
Pin 6
Ignition Controlled
12v (+)
Green
Pin 7
Orange
Pin 7
Reverse (+)
(backup lamps)
Black
Pin 8
Black
Pin 8
Ground