Owner's Manual
Table Of Contents
1270 Instructions 9-15-14.doc Page 3 of 5
Step 7: Align the (4) 3/16” holes with
mounting holes on module and insert the (4)
3/8” Pan Head T-20 Torx Screws through
tray into module.
Step 8: Cut out provided armrest lid
template, mark the locations for (1) 1/2”
hole.
Step 9: Drill the (1) 1/2” hole in lid.
Step 10: Reassemble armrest tray with
Charging Module in armrest lid and route
harness through ½” hole of lid.
Step 11: Remove rubber cup holder liner.
Step 12: Using Phillips Screw Driver remove
(2) screws in cup holder and remove.