Owner's Manual
Table Of Contents
1270 Instructions 9-15-14.doc Page 4 of 5
Step 13: Using Phillips Screw Driver remove
screws in armrest bin.
Step 14: Remove armrest bin.
Step 15: Disconnect power point.
Step 16: Splice Red wire of Power Harness to
the Red (12v ignition) wire of the keyed
accessory power point plug and Splice Black
wire of Power Harness to the Black (ground)
wire of the power point plug
RECOMMENDED: Solder wires and cover with Heat
Shrink Tubing.
Step 17: Route Power Harness to rear of
console.