Owner's Manual


FDMC-1281 Optima .doc Page 3 of 3
6. With shifter knob removed, grab on to trim
from the shifter opening and pull straight up
the unclip trim.


7. Remove console trim. Unplug the plugs on the
back of the trim.
8. Place the template tin the pocket and mark the
½ hole to be drilled for the power harness to
pass through.
9. Connect the supplied power harness to the
power point (cigarette lighter) harness.
10. Connect the red wire to the factory orange
wire, by splicing into the wire and wrapping
with tape or heat shrink when done.
11. Connect the black wire to the factory black
wire, by splicing into the wire and wrapping
with tape or heat shrink when done.
12. Remove the paper off the double-sided sticky
pad, insert the power plug of the module
though the hole drilled and place the module
into the pocket. Note: Clean the bottom of
the pocket with alcohol for a better
adhesion.
13. Plug in the module power plug to the power
harness that was wired in in step 10 and 11.
14. Plug in all factory harness that were
unplugged.
15. Reinstall console trim.
16. Turn on ignition to test charge module. The
LED light will turn on blue when powered up.
Set Qi wireless equipped phone onto mat and
the LED will change to green.
17. Reinstall trim in reverse order, be careful not
to pinch any wires.


