Owner's Manual

ManualsBrandsBrandmotion ManualsCar Audio & VideoSUTV-8857

1

2

3

4

5

6

7

8

Programming Instructions

Install Rear View Camera

Installation Instructions - SUTV-8857 Page 3/9AR_03_23_21

2 4

1. PLEASE NOTE: These modules are VIN

locked for single vehicle use. If your vehicle

ever needs a radio replaced or is ﬂashed by

a dealership, you can reprogram with this

programmer.

2. Start the vehicle. Allow it to run for 20-30

seconds before proceeding. *Failure to start

the vehicle before inserting the programming

module can cause catastrophic failure of the

module and void your warranty on this part.

3. Plug module into OBDII port, located under

the dash on the driver’s side, and wait for

the green LED to light up, then remove the

module.

4. Shift into reverse. If you get a black/blue

screen with “Check your Surroundings”,

the ﬂash has been successful and you can

proceed with testing the camera.

1. First, you need to gain access to the back

of your factory radio. Start by removing the

rubber bin insert from the top of the dash

2. Remove the 7mm bolt under the rubber bin

insert.

3. Using a plastic trim removal tool, remove the

window switch panel.

4. Disconnect harness from window switches.

5. Remove the 7mm bolt behind the window

switch panel.

Preparing the Radio

Part 1

Vehicle Application:

Jeep Wrangler JK

Part Number: SUTV-8857