Owner's Manual

6. Remove driver knee bolster cover
7. Remove (2) 7mm bolts on both sides of the
steering column.
8. Remove center stack/cluster trim
9. Remove the glove box for access. You will need
access to the area behind the glove box to make
your connection to the radio.
10. Remove (4) 7mm bolts to remove radio from dash
11. Locate the White 22 pin connector with a
female RCA that was included with your kit.
Plug the 22 pin into the open connection on the
back of your radio.
12. Run the RCA towards the passenger side
through the dash and let it rest behind the glove
box. RCA should be visible through the glove
box opening.
13. Reassemble the radio and surrounding panels,
but leave the glove box disassembled.
6 8
9 10
Installation Instructions - SUTV-8857 Page 4/9AR_03_23_21
Vehicle Application:
Jeep Wrangler JK
Part Number: SUTV-8857