Owner's Manual

Installing Rear Camera on Tire Carrier

Vehicle Application:

Jeep Wrangler JK

Part Number: SUTV-8857

Part 3

1. Remove your spare tire and place the camera

bracket on the top two studs.

2. Secure bracket to carrier using (2) push nuts to

secure the bracket on two top studs.

3. The nylon washer will go on the bottom stud

and will be secured with the third push nut.

4. Place your tire on the carrier and make any

needed adjustments to the camera placement

to see through the wheel spokes.

5. Once the orientation is satisfactory, tighten two

adjustment screws on bracket.

6. Reinstall the spare tire on the carrier.

1. Using a plastic trim removal tool, remove

interior panels on the inside of the rear gate

2. Insert camera connector through the rear

relief/vent ﬂap behind the spare tire mount.

DO NOT RUN THROUGH CENTER HOLE OF TIRE

CARRIER

3. Gently pull harness through relief door and

connect your camera harness to your chassis

harness.

4. Use supplied wire ties to secure chassis

harness to existing harness in the tailgate.

Install Rear View Camera Chassis Harness

Installation Instructions - SUTV-8857 Page 6/9AR_03_23_21