Owner's Manual

Ground (Black)

12V Power (Red)

Ground (Black)

12V Power (Red)

c. Connect twisted red and green wire to power

output from radio

d. Connect black wire to Chassis ground. We

recommend using factory chassis grounding point.

2. 8847:

3. 8857:

a. Identify red power wire exiting the back of the

yellow RCA from your camera chassis harness

b. Identify power output from your aftermarket radio

c. Connect Red wire to power output from your

aftermarket radio

d. Connect black wire to Chassis ground. We

recommend using factory chassis grounding point.

a. Connect jumper power harness to chassis

harness (if not already connected)

b. Separate power and ground wires at jumper

harness

c. Identify power output from your aftermarket

radio

d. Connect red wire to power output from your

aftermarket radio.

e. Connect black wire to Chassis ground. We

recommend using factory chassis grounding point.

1. Red = Power

2. Black = Ground

Finishing Installation

a. Connect male RCA of chassis harness to female

RCA behind glove box.

b. Test camera

c. Reassemble vehicle in reverse order of removal

1. Twist red and green together = Power

2. Black = Ground

Vehicle Application:

Jeep Wrangler JK

Part Number: SUTV-8857

Part 1

Installation Instructions - SUTV-8857 Page 8/9AR_03_23_21

White/Grey 12V Reverse Wire

Located in JK Passenger Kick panel