Installation Instructions

IMPORTANT

NOTE: The important safeguards and instructions that appear in this

manual are not meant to cover all possible conditions and situations

that may occur. It must be understood that common sense, caution and

care, are factors that can’t be built into any product. These factors must

be supplied by the person(s) caring for and operating the fixture.

STEP BY STEP INSTRUCTIONS

Before starting your installation disconnect the Power by turning off the

Circuit Breaker or by removing the fuse at the fuse box. Just turning the

light off at the light switch is not sufficient to prevent electrical shock.

PREPARE FIXTURE

If there is an existing fixture remove it.

Expose the supply wire from the outlet box.

GENERAL INFORMATION

All electrical connections must be in accordance with all ordinances,

Local and National Electrical Codes. These fixtures are intended for

mounting to a standard 4” x 2 1/2”metal octagon outlet box. The box

must be directly supported by the building structure and U.L. Recognized.

INSTALLATION INSTRUCTIONS

WHAT WE PROVIDE

•

Mounting Hardware

• Crossbar Plate

• 3 x Glass shades

• 3 x 40W G9 Bulb

CERTIFICATION: UL DAMP

APPLICATION

Wall Fixture

WHAT YOU NEED

•

Screwdriver

• Wire Cutters

• Wiring Supplies as Specified

by Electrical Code

Before assembling, please make sure thatyou carefully read through

these instruction sheets. Consider having your fixture installed by a

qualified licensed electrician.

PAGE 1
CERTIFICATION: UL DAMP INSTALLATION INSTRUCTIONS IMPORTANT Before assembling, please make sure that you carefully read through these instruction sheets. Consider having your fixture installed by a qualified licensed electrician. NOTE: The important safeguards and instructions that appear in this manual are not meant to cover all possible conditions and situations that may occur. It must be understood that common sense, caution and care, are factors that can’t be built into any product.
PAGE 2
CERTIFICATION: UL DAMP 2 MOUNT CROSSBAR PLATE Gently pull the supply wires out of the j-box. Mount the crossbar to the J-box with the supplied screws. MAKE WIRE CONNECTIONS 3 Gently pull the supply wires through the hole in the crossbar. Connect the black supply wire to the black fixture wire. Secure with the supplied wire nuts. Connect the white supply wire to the white fixture wire. Secure with the supplied wire nuts.
PAGE 3
CERTIFICATION: UL DAMP SECURE THE GLASS SHADES AND INSERT THE BULBS 5 Hold the glass shades at a slight angle to the fixture and fit over the socket spring. Do not insert shades vertically as the glass may crack. Insert the supplied bulbs. MAXIMUM WATTAGE 40W.