Assembling & Installation Instructions

ASSEMBLING & INSTALLATION INSTRUCTIONS
 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old fixture and all
hardware from Junction Box. The junction box is not include.
2. Carefully unpack your new fixture and lay out all the parts on a clear area. Take
care not to lose any small parts necessary for installation.
3. Attach the pipe thread(H) to the center coupling of the lamp body(K), by turn it
clockwise until tighten. Attach the tube(I)/cover(G) insert the pipe thread, lock
them securely with the round nut(F). Slide the electrical wires through the
tubes(E)/(D)/(C) and canopy.
4. Raise the tube(E) to top pipe thread of lamp body(K), raise the tube (D), tube
(C) and loop(B) to the pipe thread in order , then by turning it clockwise until
tight. Open the link(A), hooked the canopy and loop (B), close the link(A).
5. Install the light bulb(not included) in accordance with the fixture specifications.
NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!
This lamp bottom
luminary is LED, the manufacturer has been installed.
6. Attach the glass(J) insert to the lamp holder, rotate the glass until tighten.
7. Thread the two mounting screws into the pre-drilled holes in the Mounting plate
spaced the same distance apart as the holes in the canopy.
8. Attach the mounting plate to the Junction Box with the two Junction Box screws
as shown. The side of the mounting plate marked "GND" must face to out.
9. While holding the fixture lamp towards the ceiling , connect the electrical wires
as Shown in Fig.2, making sure that all wire nuts are secured. You may have to
wrap the connections with electrical tape. If your outlet has a ground wire (green
or bare copper), connect the fixture ground wire to it. Otherwise connect
fixture’s ground wire directly to the Mounting plate with the green screw
provided. After wires are connected, tuck them carefully inside the Junction box.
10. Raise the canopy on to the Junction box, aligning screws on mounting plate
with mounting holes in canopy and lock it securely with the ball nuts.
Your installation is now complete. Return power to the junction box
the fixture.
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black(Hot)
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or Bare
Copper(Ground)
FIG.2
FIG.1
The drawing shown may not exactly match the product enclosed.
However, the installation in structions do apply to this product.
ALL RIGHTS RESERVED
Thank you for purchasing a product.
Need assistance with parts or assembly? Please call customer service