Assembly and Installation Instructions

The following parts are available for re-order if damaged or missing.

Spare Parts List:

A: 8"

B: 18"

1. Turn off the power at the fuse or circuit box before starting installation.

2. Remove the hex nut, washer and Plate, and then Loosen the wire connectors connected with the wires from photocell.

(See Fig.1)

Note: Do not move the photocell to prevent water from seeping into the outlet box.

3. Take a white pigtail and black pigtail and make wire connections using wire connectors: (See Fig.2)

a. The black wire from the fixture to one end of the black pigtail.

b. The white wire from the fixture to one end of the white pigtail.

c. The other end of the black pigtail to the black wire from the power source.

d. The other end of the white pigtail to the white wire from the power source.

Put all wires back into the back plate of the fixture.

4. Turn on the power at the fuse or circuit box

Operation the Unit Without Photocell

Wire Connector (B)

Fitter Screw (A)

Photocell

White Wires

From Photocell

Wire Connectors

Black Wire From

Fixture

Wires From Fixture

Wires From

Main Power

Wire Connector

White Pigtail

Pigtail

Red Wires From

Photocell

Black Wires From

Photocell

Fig.1

Fig.2

Plate

Washer

Glass Shade

White Wires

From Fixture

Hex Nut

Assembly Kit (1 SET)