Owner Manual

ManualsBrandsBreakwater Bay ManualsAll Ceiling Fans72" Hellam 6 -Blade Outdoor LED Ceiling Fan with Remote Control and Light Kit Included

PAGE: 5 / 9

Installation Steps :

Fig.1

Turn OFF the electric circuit at the

main fuse or circuit breaker box.

NOTE: The fan weight is 18.7 lbs (8.5 kg). Be sure the outlet box you are using is securely attached to the building

structure and can support the full weight of the fan. Failing to do so can result in serious injury.

INSTALLATION INSTRUCTIONS

IMPORTANT:

BEFORE YOU BEGIN INSTALLING THE FAN, CAREFULLY READ ALL INFORMATION ON THE SEPARATE

SHEET "SAFETY INSTRUCTIONS" AS WELL AS THE FOLLOWING "INSTALLATION INSTRUCTIONS". IF IN

DOUBT, CONSULT A QUALIFIED ELECTRICIAN.

SAVE ALL INSTRUCTIONS.

Tighten the hanger bracket to the outlet box with two mounting screws.(Make sure

the outlet box is securely installed so that it will be able to support at least the

fan weight.) Attach the safety cable hook to the ceiling with the dry wall screw and

washer, and make sure the safety cable hook is covered by the fan canopy.

WARNING: MOUNT ONLY TO AN OUTLET BOX MARKED "ACCEPTABLE FOR

FAN SUPPORT"!

Fig.5.Fig.2.

Ceiling

Hanger Bracket

Ceiling Joist

Wood Member

(2" x 4" Approx.)

Junction Box

Washer

Safety Cable Hook

Dry Wall Screw

Ceiling

Hanger Bracket

Ceiling Joist

Wood Member

(2" x 4" Approx.)

Junction Box

Thread the motor wires through the

downrod stand cover, decorative

cap, canopy and downrod.

Collar

Hanger Pin

Lock Pin

Remove the Lock Pin and take off

the Hanger Pin.

Fig.3

Loosen the collar screws in part way.

Insert the Downrod into the Collar.

Slide Hanger Pin through holes of

Collar and Downrod.

Fig.4

Motor Wires

Downrod

Downrod Stand

Cover

Canopy

Downrod

Canopy

Downrod Stand

Cover

Fig.5

Decorative Cap

Lock Pin

Hang the fan on Hanger Bracket, and

make sure the slot of hanger ball is

snapped into the chip of Hanger

Bracket exactly.

Note: For slope ceiling installation,

make sure the slot of hanger ball and

the chip of hanger bracket face down.

Insert and tighten the two Collar

Screws. Slide Lock Pin into Hanger

Pin until it is locked into position.

Fig.6

Collar Screws

Fig.7

Slot

Chip

Hanger Bracket