Instructions / Assembly

5
Fig.1a Fig.1b Fig.1c
Fig.1e
Fig.1d
Pin
Down Rod
Setscrew
Locking Pin
Jam Screw
Down Rod
Cotter Pin
Hanger Ball
Canopy
Motor Cover
Bolt
1
3
2
1
Installation Instructions
Step1 MOUNTING
- Take out fan motor housing.
- Remove cotter pin and bolt from yoke.
- Loosen jam screw in yoke until it is flush with the inside surface.
- Obtain downrod, canopy and yoke cover.
- Place downrod inside canopy and yoke cover.
- Route wires exiting motor through yoke cover, canopy and downrod.
- Insert bolt through hole in and downrod. Be careful not to damage or cut the fan wires
-Tighten bolt. Secure with cotter pin through hole in the end of the bolt.
- Secure downrod in position by tightening jam screws.Side yoke cover down and t will flush
with the motor housing.
CAUTION: To ensure wobble-free operation and to avoid damage to the fan, the downrod
and the set crew must be completely tightened.
Canopy Cover
Metal Cover
Canopy
Motor Cover
Canopy Cover
Metal Cover
3
2
Warning:
Turn off the power for your own safety
At the fuse box or circuit breaker Before all your actions.
Down Rod