Instructions / Assembly

FF
L
N
N
12
Operation
WARNING: Do not short-circuit, disassemble, heat up,
connect improperly, or dispose of used batteries in fire. Do
not recharge or mix batteries with used or other battery
types. Immediately remove used batteries.
WARNING: a)The cells shall be disposed of properly,
including keeping them away from children; and
b) Even used cells may cause injury.
NOTE: After the AC power is on, do not press any other button
on the remote control before pressing the (FAN ON/OFF)
button. Doing so will cause the procedure to fail.
REMOTE CONTROL OPERATING INSTRUCTIONS
Install a 12V battery (L) into the remote control (N). Fasten the battery
cover screw (FF) after installation. To prevent damage to the remote
control, remove the battery if not used for long periods of time.
LEARNING PROCESS
WARNING: Chemical Burn Hazard. Keep batteries away
from children. This product contains a lithium button/coin
cell battery. If a new or used lithium button/coin cell battery
is swallowed or enters the body, it can cause severe
internal burns and can lead to death in as little as 2 hours.
Always completely secure the battery compartment. If the
battery compartment does not close securely, stop using the
product, remove the batteries, and keep it away from
children. If you think batteries might have been swallowed
or placed inside any part of the body, seek immediate
medical attention.
NOTE: After turning the AC power back on, do not press any
other button on the remote control before pressing the
button. Doing so will cause the learning procedure to fail
and the power to the fan will have to be turned off again to
start over.
Turn main power to fan back on and within 30 seconds
press and hold the button on the remote for 5 seconds
to sync the transmitter to the fan.
Once the fan has detected the remote, the light on the fan
will blink twice to indicate your fan is now ready to use.
Fans without light-kits have no indicator but will be ready to
use after holding the button for the 5 seconds.