Operation Manual

– If you feel lubrication or your fingertips are shiny, there is sufficient

lubrication on the running belt.

–

If you do not feel lubrication or your fingertips are dusty or rough, apply

lubricant (15-20 ml) in the middle of the running deck under the running belt

and let the equipment operate at 5km/h for at least 5 minutes.

– After lubrication, do not fold the equipment before having done a workout for

20 minutes with a speed of at least 5 km/h. The lubricant will be spread

evenly over the running belt.

Aligning the running belt (fig. I)

The running belt must run in the center of the rollers. If the running belt is pushed to

one side, the running belt must be aligned using the adjustment bolts at the rear of

the equipment.

CAUTION

– Make sure that the running belt is aligned correctly to prevent

damage to the edges of the running belt.

1. Set the mains power switch to the on position.

Set the speed to 5 km/h.

3. If the running belt runs in the center of the rollers, the running belt is aligned

correctly.

4. If the running belt drifts to the left, turn the left adjustment bolt 1/4 turn clockwise

and the right adjustment bolt 1/4 turn counterclockwise.

5. If the running belt drifts to the right, turn the right adjustment bolt 1/4 turn

clockwise and the left adjustment bolt 1/4 turn counterclockwise.

6. Repeat the last 2 steps until the running belt is aligned to the centre.

Adjusting the running belt tension

The running belt tension must be adjusted when it starts to slip on the rollers. The

running belt tension must be adjusted using the adjustment bolts at the rear of the

equipment.

26 RN3