User manual

6
D
Operating Instructions Rechargeable LED work lamp 10 W
SWITCHING THE LAMP ON/OFF:
BATTERY LEVEL INDICATOR B:
Displays the current charging status of the battery, or, how much energy is still available.
If all 4 LEDs are lit, the battery is fully charged. If the battery is nearly empty, theLEDblinks
5timesandthe battery statusindicatorblinkscontinuously.Then the lampwillremainlit for
approx. 5-10 minutes, before the deep discharge protection shuts the lamp o. This leaves
enoughtimetonishworking.
CHARGING UNITS WITH A USB CABLE E.G. SMARTPHONES:
Suitableforproductswithachargingcurrentofupto1000mA.TochargetheunitwithaUSB
cable,connectittotheUSBchargingport(C)underthetransparentcoveronthebackoftheunit.
Closethecapaftercharging.
CHARGING THE BATTERY:
• Toensureoptimumfunctionality,werecommendcompletelydrainingtheintegratedbattery
duringtherstuseandthefullyrechargeit.
• ThemicroUSBchargingport(D)forchargingthebatterisunderthetransparentcaponthe
backoftheunit.ConnectthechargingporttoaconventionalUSBpowersupplyunit,
asusedforsmartphones,digitalcameras,etc.,usingtheprovidedUSBcable.
Thechargingtimedependsonthepowersupplyunitandis,forinstance,approx.4.75hours
withachargingcurrentof1A.
• Usethebatterylevelindicator(seedescriptionabove)todeterminethebatterylevel.
Ifall4LEDsarelit,thebatteryisfullycharged.
• Thelampcanbeoperatedwhilecharging,however,ithastobeswitchedto50%mode.
Thechargingdurationincreasessignicantlyinthisoperatingmode.
• Ifthelightisnotusedforanextendedperiodoftimethebatterymustbecharged
approximatelyevery3monthstoensurealongbatterylifespan.
• Aftercharging,makesuretoclosethechargingportwiththecap.
B
C
A
D
Pressthebutton(A)toswitchthelampon.
The light will shine at 100% brightness. If the button is
pressedagainwithin2 seconds,thelamp will switch to
50% mode. When selecting 50%, the service life of the
lamp extends in comparison to the 100% setting as it
consumeslessenergy.
Pressthebuttonagaintoswitchthelampo.
16P146 Akku LED Arbeitsstrahler_170327.indd 6 28.03.17 11:06