Operation Manual

Inserting the battery
Caution!
Make sure the battery is aligned with the correct pole.
Incorrect insertion of the battery may result in property
damages.
1. Open the cover (7) on the battery compartment (9).
2. Insert the battery as shown in the figure.
3. Close the battery compartment (9).
4. Press any button on the remote control (4). The function
lamp (5) will illuminate when the button is pressed.
If the function lamp (5) does not illuminate when the
button is pressed, the device is not receiving any power
from the battery.
Check to ensure the battery has been installed properly.
Synchronize the system code
Prior to initial use of the devices, the system code must be
synchronized so all of the switch outlets react to the wireless
signal from the remote control.
In addition, each switch outlet must be assigned a frequency
from a button pair on the remote control so each switch out-
let can be operated separately.
Adjust the DIP switch with a suitable object, for instance
a small screwdriver by sliding the DIP switch up or down.
Setting the system code on the remote control
1. Open the cover (7) on the battery compartment (9).
14
RCS 1044 N Comfort
079515 BA_Funkschaltset RCS 1044 N.qxp 24.09.15 08:41 Seite 14