Warranty

Using Your Stand Mixer:

1. Place the Stand Base on a clean and sturdy flat surface. Press the Tilt/Open Button on the

side of the Stand Base to tilt the head back.

2. Insert the Stainless-Steel Bowl in place, then lock by turning clockwise. Insert

the beaters into Mixer. *Make sure the grooves of the Mixer Holder lock with

the grooves of the Mixer.

3. Add the ingredients you would like to mix to the Bowl then lower the

beaters or hooks into ingredients.

4. Connect Plug to the nearest electrical outlet. Mix using a slower speed at

first, gradually building.

Note: Use beaters if beat eggs. Use hooks if mix thick sticky flour.

Note: During mixing dough, add water in bowl first, then add four. Use your hand to

rotate bowl for about 2~3 minutes, after that bowl can be rotating itself.

CAUTION: Do not touch Moving parts with fingers or objects.

Attention: First use may cause a slight odor or small smoking upon heating, it is normal. This

is a result of the heating element chemical reaction. It quickly goes away.

Caution: do not operate for more than 5 min at a time. Allow unit to rest for 2 min to avoid

overheating

5. Mix ingredients to the desired consistency and turn the dial back to “0” to turn off,

disconnect from the power supply to clean.

6. You can eject the beaters by pressing down firmly on the Eject Button.

7. You can remove the bowl by holding base with one hand then turning the bowl

counterclockwise.

Speed

Description

1 : Start

This is a good speed for thick and dry foods such as flour, butter and potatoes.

2 : Blend

Best speed to start liquid ingredients for mixing salad dressings.

3 : Mix

For mixing cakes, cookies and quick breads.

4 : Cream

For creaming butter and sugar, beating uncooked candy, desserts, etc.

5 : Whip

For beating eggs, whipping potatoes, whipping cream, etc.

Cleaning Your Stand Mixer:

WARNING: Always unplug the product before cleaning or storing it.

NOTICE: Never immerse the motor base, plug or cord in water or any other liquid.

• It is recommended to rinse parts immediately after use to make cleaning easier.

• Beaters and Stainless-Steel Bowl can be washed using warm soapy water and nonabrasive

soap. Do not use abrasive cleaners or pads. Rinse and dry all parts thoroughly.

• The motor base may be wiped using a damp cloth. Reassemble and store in a cool, dry

place. Away from reach of children.

NOTE: NEVER IMMERSE THE BASE