User's Manual

12
NOTE
When the purifier fan heater is on and correctly
setup to the Wi-Fi network, Wi-Fi will attempt
to connect automatically. If a connection
has been made, the Wi-Fi symbol will flash
for 60 seconds, after 60 seconds, the Wi-Fi
symbol will illuminate on the LED display. If a
connection is not made, the Wi-Fi symbol will
stop illuminating. See Wi-Fi Connectivity in
this book for more details.
SENSAIR SYSTEM
®
LIVE PURITY MONITOR
• Your Breville AirRounder Plus™ Connect
Purifier Fan Heater has a built-in air quality
monitor to detect changes to air quality in the
surrounding area.
• The SensAir System
®
air quality pattern
on the LED display panel will change
colours according to the quality of the
surrounding air.
• The LED screen provides real-time indication
of fine particles PM2.5 concentration.
Grade
Air
Quality
AQI*
Measured in
PM2.5
Colour of
air quality
pattern Light
1 Very Good 0-33 Blue
2 Good 34–66 Bright Purple
3 Fair 67–99 Orange
4 Poor > 100 Red
* Air Quality Index Based on the Australian Air National
Environment Protection Measure (NEPM) standard.
Functions
OPERATING YOUR PURIFIER
FAN HEATER
NOTE
The purifier automatically operates when
either Heating or Cooling is turned on. It is
recommended to use the Low Fan setting
to purify the surrounding area when a room
temperature adjustment is not required.
Place the purifier fan heater on a flat surface.
Insert the power plug into a 230V or 240V
power outlet and switch on at the outlet. When
switched on, a chime will sound to confirm the
unit is switched on and it is in standby mode.
1. Touch the
button on the control panel
or press the button on the remote control
to turn the purifier fan heater on. When
switched on for the first time, the purifier
fan heater will start automatically in heating
mode, at medium heat level and 25°C as the
default set temperature.
2. The LED display screen will illuminate,
and the light ring will illuminate with a red
colour light.
3. To turn the purifier fan heater off at any
time, touch the
button on the control
panel or press the button on the remote
control. When switched off, a chime
will sound to confirm the unit has been
switched off, the light ring will no longer
illuminate, and the unit will go into
standby mode.
4. To adjust how the purifier fan heater
operates, follow the directions below.