User's Manual

14
NOTE
Choose the heat setting to determine how
quickly the purifier fan heater will maintain the
set temperature setting.
NOTE
When the purifier fan heater is turned on from
standby, the memory function will start heating
based on the previously set temperature and
heating setting.
NOTE
When operating the purifier fan heater
remotely in heat mode, the purifier fan
heater will automatically switch off after
7hrs by default.
SET TEMP & SENSAIR
1. The purifier fan heater will stop heating and
purifying when the ambient temperature
is greater than the set temperature (e.g.
>25˚C) and the air quality is very good (AQI
Measured 0-33).
2. Ambient temperature will flash, the
light ring will no longer illuminate, and
oscillation will stop. The unit will start
heating and purifying again when the
ambient temperature is less than the set
temperature (e.g. ambient temperature < set
temperature 25˚C). Ambient temperature
will stop flashing, the light ring will turn
on and oscillation will resume at the
same angle as previously set, only if the
oscillation button is touched on the control
panel or pressed on the remote control.
3. If the ambient temperature is greater than
the set temperature, but the AQI is over 33,
the unit will stop heating but continue to
purify using low fan.
NOTE
If the AQI measured is over 33, the unit will
stop heating and fan setting will automatically
change to low.
Night Mode
Your purifier fan heater is fitted with a light-
sensitive sensor that will intelligently stop
the LED display screen and light ring from
illuminating at night or when in a dark place.
The Night mode will automatically turn off
the light ring and all lights on the LED display
panel and will operate in the last setting.
Touch any button on the control panel or press
any button on the remote control to re-engage
the LED display panel.
TIMER
AUTO-OFF TIMER
The purifier fan heater comes with a
7-hour auto-off timer to turn off after a set
number of hours.
The purifier fan heater can be set in 1 hour
increments up to 7 hours. After the selected
number of hours have elapsed, the purifier fan
heater will switch to standby mode. If no timer
is set, the purifier fan heater will continuously
operate until it is manually switched off.
AUTO-OFF TIMER Example: Set the auto-off
timer to 3 hours, and the purifier fan heater
will stop operating after 3 hours. 1h and 2h will
illuminate on the control panel LED lights.
The auto-off timer can be set in any MODE.
To set the timer, tap the
button repeatedly
on the control panel or press on the remote
control until the desired number of hours
displays on the control panel LED lights. The
timer will start on the selected mode, and will
stop automatically once the timer has expired.
The control panel LED lights will illuminate
the remaining auto-off time.
REMAINING TIME Example: Set the
auto-off timer to 3 hours, once 1 hour has
elapsed, the remaining time will be displayed
in a decremental way, whereby 2h will
only illuminate on the control panel LED
lights, after another hour has elapsed 1h will
illuminate on the control panel LED lights until
the set time has completely elapsed.