Specifications

60GHzand80GHzProductsNMSManual
11 58000511rev.F
4. Select‘SubmitNewValues’atthebottomofthe‘Setup’page.Aredvaluewillbe
displayedundertheCurrentEffectiveValuescolumn.Clickthe‘Setup’tabtorefreshthe
browserwindowuntiltheCurrentEffectiveValueisnolongerdisplayedinred.
4.3 FiberInterface
AllBridgeWave60GHzand80GHzradiosarefittedwithaGigabitEthernetfiberinterface,
regardlessofwhethertheradioisoperatinginFE(100Mbps)orGE(1000Mbps)modeoverthe
air.Twooptionsareavailableforthefiberinterfaceoftheradiounit.
· 1000BaseSXoption:Designedfor850nmmultimodefiber.
· 1000BaseLXoption:Designedfor1310nmsinglemodefiber.
Forbothoptions,theonlysettingthatcanbechangedistoenableordisableautonegotiation.
Whenautonegotiationisdisabledflowcontrolisalsodisabled.Theunitsaresetwithauto
negotiationenabledasthefactorydefault.
ItisimportantthattheBridgeWaveradioandthecustomernetworkequipmentinterfacesbe
configuredidentically;bothinterfacesshouldbeconfiguredtoautonegotiateorelsebothshould
beconfiguredtonotautonegotiate.
Whenautonegotiationisdisabledonthefiberinterface,flow
control willalsobedisabled.Iftheradioandthenetwork
equipmentareconfigureddifferently,itislikelythata
connectionwillnotbeestablishedoverthefiberorthattraffic
flowsmaybeimpaired.
Thefiberinterfaceontheradioandtheattachedswitch should
besettoautonegotiatewhenusingtheA daptR atefeatureon
ARmodels. Thiswillallowflowcontroltoassertbackpressure
onthenetwork,viapauseframes,whenoperatingin100Mbps
FastEthernetmode.Thiswillassistwithpreventingcongestion
andprovideforhigherQualityofService(QoS)whenstepping
from1000Mbpsdownto100Mbpsmode.
UsethefollowingstepstoconfiguretheFiberInterface:
1. Connecttothewebmanagementinterfaceoftheunit,andselectthe‘Setup’tab.
2. Underthe‘FiberInterface(GigE)’section,select‘Enabled(Default)’or‘Disabled(flow
controloff)’.