Specifications

60GHzand80GHzProductsNMSManual
13 58000511rev.F
Fiber
TX
RX
RX
TX
RX TX
TX
RX
Fiber
RXTX
TX
RX
SecondaryRadioPath
CopperCopper
Figure41 AdaptPath™Technology
UsethefollowingstepstoconfiguretheAdaptPath™feature:
Aftertheequipmentisinstalled,performthefollowingsuggestedstepstosetuptheLSPfunction
inanARsystem:
1. Inthe‘Setup’pageonbothRadios,settheRadioLSPtoFiberselectionto‘Enabled’
2. IntheHighbandradio,presstheFEDefaultSwitchPointsbuttontosettheRSLtrigger
pointstoachieveGEtoFEandthentoLSPrateswitching.TheRSLfieldswillthenbe
filledinwiththedefaultvalues.(TheLowbandradioRSLActivationfunctionisgrayed
out)
3. Setthe‘AccessControl’to‘OutBand(CopperManagementOnly)’atbothHighand
Lowbandradios
4. Pressthe‘SubmitNewValues’buttonatbothradios.
5. TheHighbandRadioTXwillnowbemuted,TheHighBandRXwillreadgreenRSL
butRedLink.TheLowBandRXwillreadRedRSLandRedLink.