Specifications

60GHzand80GHzProductsNMSManual
15 58000511rev.F
Fiber
TX
RX
RX
TX
RX TX
TX
RX
Fiber
RXTX
TX
RX
CoreNetworkRedundantPath
SwitchPortGets
NotifiedTha tLinkIsDown
HighBand
Radio
LowBand
Radio
SwitchPortGets
NotifiedThat LinkIsDown
Copper
(Management)
Copper
(Management)
Figure42 LSP
LSP: Accesstothe webandSNMPmanagementfunctionalitywill
notbepossibleiftheradioisbeingmanagedInbandthroughthe
fiberinterfaceandLSPhasdisabledthefiberinterf ace.
Restorationoftheradiolinkwill berequiredinordertoregain
accesstothe equipment.
IftheLSPfeatureisenableditishighly recommendedtoenable
copperInBandorOutBandmanagement.Thiswillallowfor
accesstothe unitsiftheradiolinkisinadownstate.
LSP: LSPrecoversfasterifautonegotiationisdisabledonthe
fiberinterfaceoftheradio.Itisrecommendedtodisableauto
negotiationandflowcontrolontheattachednetworkequipment
anddisableautonegotiationontheradiosfiberinterfaceifusing
theLSPfeature.
UsethefollowingstepstoconfigureSynchronousLSP:
Aftertheequipmentisinstalled,performthefollowingsuggestedstepstosetupthefunction.
1. Inthe‘Setup’page,setbothHighbandandLowbandradiosRadioLSPtoFiber
selectionto‘Enabled’
2. IntheHighbandradio,andforAR,pressbothoftheDefaultSwitchPointsbuttontoset
theRSLtriggerpointstoachieveGEtoFEandthentoLSPrateswitching.TheRSL
fieldswillthenbefilledinwiththedefaultvalues.ForGEorFeonlysystems,onlyone
FEorGEdefaultbuttonwillbeavailable.