Specifications

60GHzand80GHzProductsNMSManual
20 58000511rev.F
3. Clickthe‘SubmitNewValues’buttonatthebottomofthe‘Setup’pageforthechanges
tobecomeactive.
4.7 IPSetup
Thenetworkaddressingoptionsareconfiguredfromthe‘IPSetup’pageofthewebmanagement
interface.Thenetworkadministratorwouldtypicallyprovidethesevalues.
UsethefollowingstepstoconfigureIPSetupparameters:
1. Connecttothewebmanagementinterfaceoftheunitandselectthe‘IPSetup’tab.
2. Underthe‘ManagementAgent’sectionconfiguretheparameterslistedbelow:
DynamicHostConfig–CheckingtheDHCPboxenablestheunittoreceiveanIP
address,subnetmaskanddefaultgatewayfromthenetwork’sDHCPserver.Unchecking
theboxdisablestheDHCPfunction.
IPaddress–AllowsforstaticconfigurationoftheIPaddressforthemanagementagent.
ThefactorydefaultfortheLowBandradiois192.168.0.1andtheHighBandradiois
192.168.0.2.
Subnetmask –Thesubnetmaskcanbeconfiguredbypickingthedesiredvaluefromthe
Pulldownmenu.
DefaultGateway– Setsthedefaultgatewayaddressforthisradio.Leaveblankifno
defaultgatewayistobeused.
3. Select‘SubmitNewValues’atthebottomofthe‘IPSetup’page.Thecurrentvalueswill
bedisplayedinRedundertheCurrentEffectiveValuescolumn,alongwitha(Soft
RestartPending)message.
4. Clickthe‘SoftRestart’option atthebottomofthe‘IPSetup’pagetomaketheNew
Valuesactive.
A‘SoftRestart’isrequiredbeforeachangetotheManagement
Agentparameterswillbecomeactive.