Communications, Inc. Switch User Manual



GE/AR80 Installation Manual

580-00519, rev A 34 of 40

4.1 Configuring Network Equipment

The networking equipment that is connected to the GE/AR80 should be checked to

ensure it operates properly over a wired connection. Once this has been confirmed it will

save troubleshooting steps after the radio is installed and connected to the network

equipment.

We strongly recommend the network equipment on both sides of the link be configured

as follows:

• 1000Mbps full-duplex

• Port configured not to enter error-disable state due to link up/down transitions

(since these may occur during periods of very heavy rain)

• For AR model only, ensure to disable the, Installation Auto-Calibration selection

via Set Up GUI section, post installation.

4.2 Check Port Statistics on the Network Equipment

the event the network equipment connected to the GE/AR80 offers the capability

below, we recommend you verify the following on the network equipment:

• Link integrity

• There are no receive errors on the link

• Network traffic is flowing in both directions

* For pricing and a quotation, visit MeridianMicrowave.com