Installation Guide

Setscrew
Install 2x4 backing flush with the studs,
at the installation location.
Install a 1/2” NPT supply pipe to extend
no more than 1/2” (13mm) beyond the wall.
Secure the supply pipe to the 2x4 backing. Complete the finished wall. Provide a
1-5/16” (33 mm) hole around the supply
pipe.
Slide the mounting plate on the faucet
shank.Tighten the setscrew into the
groove.
INSTALLATION PROCEDURES
1
Thread the shank to the supply pipe
so the mounting plate is flush.
6
Position the mounting plate over the
holes with the setscrew hole down.
Secure with the screws.
11
Slide the escutcheon onto the shank.
12
Use a strap wrench to secure the faucet
to the supply pipe.
13
Align the faucet groove with the setscrew
hole in the mounting plate. Tighten the
setscrew.
14
Slide the escutcheon against the wall
with the setscrew down. Tighten the
setscrew.
15
Mark the four screw hole locations with
the setscrew down.
7
Remove the faucet from the supply
pipe. Remove the mounting plate
from the shank.
8
Drill four 1/8” holes at the marked
locations.
9
Apply thread sealant to the supply pipe.
10
2
3 4
5
These surfaces to
be flush.
1/2"
(13 mm)
Max
Secure here.
Ø 1-5/16"
(33 mm)
Setscrew
x4
Setscrew
Setscrew
Groove
3
2
Turn both handles fully clockwise to the off
position.
16