Use and Care Manual

Not for
Reproduction
14 BRIGGSandSTRATTON.COM
Troubleshooting
Problem Cause Correction
Pump has following
problems: failure to produce
pressure, erratic pressure,
chattering, loss of pressure,
low water volume.
1. Water inlet is blocked.
2. Inadequate water supply.
3. Garden hose is kinked or leaking.
4. Clogged water inlet screen.
5. Spray tip is obstructed.
1. Clear inlet.
2. Provide adequate water flow.
3. Straighten garden hose or replace if leaking.
4. Clean or replace water inlet screen.
5. Clean spray tip.
Unit fails to start when spray
gun trigger is squeezed.
1. Water supply is not turned on.
2. Unit is not turned on.
3. Garden hose is too long.
4. Fuse blown or circuit breaker tripped.
1. Turn on water supply.
2. Press the master ON/OFF switch to the
ON (I) position. Reset GFCI.
3. Use only 50 ft. (15.24 m) maximum
garden hose.
4. a.) Replace fuse or reset circuit breaker.
b.) Disconnect other electrical
appliances and turn off lights in the
circuit, or operate on dedicated circuit.
c.) Run 5 minutes with turbo spray tip.
Detergent fails to mix with
spray.
1. High pressure tip is installed. 1. Install soap tip.
Hose connections leaking.
1. Garden hose loose to water inlet.
2. Loose high pressure hose connections.
3. Damaged o-ring.
1. Hand tighten garden hose.
2. Remove hose and reinstall.
3. Replace o-ring.