Manual

Troubleshooting
Problem
Engineisrunning, but no AC
output is available.
Enginerunsgood at no-load but
"boOs down" when loadsore
connected.
Oaase
1. Circuit breaker is open.
2, Fault in generator.
3. Poor connection or defective cord set.
4. Connecteddevice is bad.
1, Short circuit in a connected load,
2. Enginespeed is too slow.
3. Generator is overloaded.
4, Shorted generator circuit.
1, Engineswitch set to stop (0) position.
2, Fuel Valve is in "Off" position.
3, Low oil level,
Correction
1, Reset circuit breaker.
2, Contact authorized service facility,
3, Check and repair.
4. Connect another devicethat is in good
condition.
1. Disconnect shorted electrical load.
2. Contact authorized service facility.
3. SeeDon't OverloadGenerator in
Operationsection.
4. Contact authorized service facility.
1, Set switch to run (I) position.
2, Turn fuel valveto "On" position.
3, Fill crankcaseto proper level or place
Enginewiii not start; or starts
and tans roagh; or shots down
when tanning.
.
5.
6.
7,
8.
9.
10,
Dirty air cleaner,
Out of fuel,
Stab fuel,
Spark plug wi::_:Oct
plug,
Bad
FIoode_.
generator on level surface.
4. Cl place air cleaner,
5. ank.
..... fuel tank and carburetor; fill with
...........fuel.
7 _onnectwiretosparkplug,
8. Replacespark plug.
9, Drain fuel tank and carburetor; fill with
fresh fuel,
10. Wait 5 minutes and re-crank engine.
Enginelackspower.
Engine"hunts" or falters.
11. Excessivelyrich f_!
12. intake valve 5 uc_ Openor closed,
13, Engineh:d_b_ @mpression.
1_ s h.
2, filter,
Carburetor is running too rich or too ban,
11, Contact authorized service facility',
12. Contact authorized service facility,
13, Contact authorized service facility,
1, See Don't OverloadGenerator in
Operationsection.
2. Replaceair filter.
Contact authorized service facility,
21