Manual

Assembmy
Your generator requires some assembly and is ready for use
after it has been properly serviced with the recommended
fuel and oil level is verified.
if you haveany problemswith the assemblyof your generator,
pleasecall the generatorhelplineat [phone]. if calling
for assistance,pleasehavethe model, revision, and serial
number from the identificationlabel available.Seegenerator
Featuresand Controls for identification labellocation.
Unpack Generater
1. Set the carton on a rigid, fiat surface.
2. Removeeverything from carton except generator.
3. Opencarton completely by cutting each corner from
top to bottom.
4. Leavegenerator on carton to install wheel kit.
The generator is supplied with:
* Operator's manual
° Axle
° Wheelkit
Mnstatl Wheel Kit
NOTICE Wheel kit is not intended for over-the-road use.
You will needthe following tools to install thesecomponents:
, 13 mm wrench
, Socket wrench with a 13 mm socket
, Pliers
, Safety glasses
install the wheel kit as feiiews:
1. Tip generator so that engine end is up.
2. Slide axle (A) through both mounting brackets.
3. Slide a wheel (B) over the axle.
4. Placea washer (C) on axle and then place an e-ring (D)
in axle groove.
5. Install e-ring with pliers, squeezingfrom top of e-ring
to bottom of axle.
,a, CAUTION E-rings could causeeye injury.
E-rings could spring backand becomeairborne
when installing or removing, resulting in
moderate injury.
, Alwaysweareyeprotectionwheninstalling/removinge-rings,
6. Repeatstep 3 thru 5 to secure second wheel.
7. Attach support leg (E) using two 13mm wrenches with
25mm capscrews (F) and lock nuts (G).
8. Return generatorto normal operating position (resting
on wheels and support leg).
9. Center lifting handleIH} on support leg end of cradle.
Attach handle using two 13mm wrenches with 45mm
capscrews (J) and lock nuts (G).
10. Check each fastener to ensure it is secure.