Full Product Manual

Not for
Reproduction
EN5
Features and Controls
120 Volt AC, 20 Amp, GFCI Duplex Receptacles — Used
to supply 120 Volt AC, single phase, 60 Hz power for
electrical lighting, appliance, tool and motor loads.
120/240 Volt AC, 30 Amp Locking Receptacle — Used to
supply 120 / 240 Volt AC, single phase, 60 Hz power for
electrical lighting, appliance, tool and motor loads.
Circuit Breakers (AC) — The 120 Volt AC, 20A GFCI duplex
receptacles are provided with “push to reset” 20 Amp
circuit breakers to protect the generator against electrical
overload.
CO Guard™ Carbon Monoxide (CO) Shutdown Indicator
Light — Indicates the engine shutdown due to carbon
monoxide accumulation around the generator or a CO
Guard system fault occurred.
Hour Meter — Displays and records how many hours your
generator has run (up to 9,999.9).
Low Oil Shutdown — This unit is equipped with a low oil
protection device. Oil must be at proper level for engine
to run. If the engine oil drops below a preset level, an oil
switch will stop the engine. Check oil level with dipstick.
Rocker Switch Circuit Breaker — The 30 Amp locking
receptacle is provided with a 2 pole rocker switch circuit
breaker to protect the generator against electrical overload.
Start Switch — Turn key to START position to start engine.
Turn key to OFF position to switch off engine.
120/240 Volt AC, 30 Amp
Locking Receptacle
120 Volt AC, 20 Amp
GFCI Duplex Receptacles
Circuit Breakers
Low Oil
Shutdown
Compare the illustrations with your generator to familiarize yourself with the locations of various
controls and product warnings.
Hour Meter
202997
Start
Switch
Rocker Switch
Circuit Breaker
CO Guard™
Carbon Monoxide
(CO) Shutdown
Indicator Light