Operating Guide

12
Skid Shoe Height Adjustment
DANGER
Amputation hazard
The discharge chute contains a rotating impeller to throw
snow. Fingers can quickly become caught and traumatic
amputation or severe laceration will result. Hand contact
with the rotating impeller inside the discharge chute is the
most common cause of injury associated with snowthrow-
ers.
Turn the engine OFF, wait for all moving parts to stop, and
remove the engine key before performing any maintenance
or repairs.
This snowthrower is equipped with two skid shoes secured to
the outside of the auger housing. These adjust the height of
of the front of the snowthrower.
When removing snow from a hard surface area such as a
paved driveway or walk, raise the skid shoes to bring the
front of the snowthrower down.
When removing snow from gravel-covered or uneven surfac-
es, lower the skid shoes to bring the front of the snowthrower
up. This will help to prevent rocks and other debris from being
picked up and thrown by the augers.
1. Determine the clearance needed between the scraper
bar at the bottom of the auger housing and the ground.
WARNING
Thrown objects hazard
Objects such as gravel, rocks, or other debris, if struck
by the impeller, may be thrown with sufficient force to
cause personal injury, property damage, or damage to the
snowthrower.
Be sure to set the skid shoes at the proper height to main-
tain ground clearance for the type of surface being cleared.
5
2. Place a block with a thickness equal to the desired
ground clearance under the scraper bar.
3. Loosen the skid shoe mounting nuts (A, Figure 5) and
push the skid shoe (B) down until it touches the ground.
Re-tighten mounting nuts.
4. Set the skid shoe on the other side at the same height.