Operating Guide

15
English
en
NOTE: If the auger or traction cables become stretched or
are sagging, adjustment is necessary.
1. Loosen finger nut (A, Figure 11).
2. Hold control cable (B) to keep it from rotating.
NOTE: The cable should not rotate while making adjustment.
3. Turn collar (C) to remove slack but do not over-tighten.
4. Tighten finger nut.
5. Perform snowthrower safety test to ensure proper opera-
tion. See Safety System Tests. If necessary, make addi-
tional adjustments.
Auger and Traction Cable Adjustment
WARNING
Amputation hazard
Over-tightening the auger cable may cause the auger drive
to engage without depressing the auger drive control.
Follow the adjustment procedure to ensure the cable is not
over-tightened.
11
C
A
B
If the speed control rod requires adjustment, see an autho-
rized dealer.
Speed Control Rod Adjustment

tire pressure is stamped on the sidewall of the tires. Do not

Checking Tire Pressure
WARNING
Explosion hazard

could result in serious injury.
