Owner`s manual

20
21
When positioning this child •
seat in booster mode use
the vehicle’s lap-shoulder
belt to secure the child and
child seat into the desired
seating position.
In booster mode, this child •
seat can be positioned
on the vehicle seat using
LATCH. Use the vehicle’s
lap-shoulder belt to secure the child. Ensure that the LATCH system does
not interfere with the vehicle belt function and alignment when securing
your child.
Harness Mode
NOTE: This seat is shipped with the recline block in booster mode.
IMPORTANT:
This child seat can be installed using LATCH, a lap-shoulder belt, or a lap belt •
only.
The recline block must be •
rotated to the front when
installing the child seat in
harness mode.
Based upon your vehicle’s •
seat belt configuration,
you may achieve a more
secure installation using
one of two approved lap-
shoulder belt path options (long belt path or short belt path). If the first
installation method results in more than 1” (2.5 cm) of front-to-back or side-
to-side movement at the belt path, then try the other option. See page 24 for
information on selecting a belt path to install this child seat in your vehicle.
This child seat can be used in harness mode with children at least 2 years •
of age and 25 – 80 lbs (11.3 – 36.3 kg) who stand 30 – 53 in. (76.2 – 134.6
cm) in height. Britax recommends using harness mode to 80 lbs (36.3 kg).
See the Child Size: Height and Weight Limitations section on page 4 for
information on when your child has outgrown harness mode.
Booster Mode
The recline block must be •
rotated to the back when
positioning the child seat
in booster mode.
This child seat can be used •
in booster mode with
children who stand 42 –
60 in. (106.7 – 152.4 cm)
in height and weigh more
than 40 lbs (18.1 kg). Britax recommends using harness mode to 80 lbs
(36.3 kg). See the Child Size: Height and Weight Limitations section on
page 4 for information on when your child has outgrown harness mode.
WARNING:
Install forward-facing only.•
Do not use anything to raise the child seat off of the vehicle seat.•
When using the LATCH connectors you must also use the top tether. If LATCH •
anchors are not available, you must use vehicle belt installation methods. The
child seat is shipped prepared for use in harness mode with the exeption of
the recline block position. Refer to your vehicle owner’s manual or contact the
vehicle manufacturer for the maximum weight rating for the LATCH anchors
in your vehicle. Use the vehicle belt (not LATCH connectors) for installations
with children who weigh more than the vehicle LATCH anchor limit. Unless
specified otherwise by the vehicle manufacturer, assume a 40 pound (18.1 kg)
child is the vehicle LATCH anchor limit.
Always use the Versa-Tether for children weighing 65 – 80 lbs (29.5 – •
36.3 kg) in harness mode.
Long belt path is only for use with a lap-shoulder belt. Never use the long belt •
path option with LATCH or a lap belt.
Recline
block
WARNING: Use only the vehicle’s lap and shoulder belt system
when restraining a child in booster mode. Never restrain a child with
a lap belt only in booster mode.
Harness Mode
Booster Mode
General Information General Information