Owner`s manual

22
23
LATCH – Short Path Only
Checklist for proper installation:
Does your vehicle:
Have a top tether anchor? 9
Always use the Versa-Tether *
for children weighing 65 – 80
lbs (29.5 – 36.3 kg). Britax
recommends that the Versa-
Tether be used at all times.
Have LATCH anchors? 9
Check your vehicle owner’s manual for the vehicle’s latch anchor limits. *
IMPORTANT: When using the LATCH connectors you must also use the
top tether. If LATCH anchors are not available, you must use vehicle belt
installation methods.
Rotate the recline block to harness
3
position.
Harness Mode
Harness Mode
Remove the Versa-Tether from the 1
storage clip.
Loosen the tether and place over
2
the child seat back.
Place the child seat on the vehicle
4
seat.
Locate the LATCH anchors in your
5
vehicle.
Verify that the LATCH strap is not
6
twisted.
Attach the LATCH connectors to 7
their adjacent LATCH anchors.
Push the child seat into the vehicle
8
seat and pull the loop end of each
LATCH strap through the belt slot
to tighten.
Repeat as necessary.*
Attach and tighten the
9
Versa-Tether.
IMPORTANT: Ensure any
excess Versa-Tether
®
webbing
is contained within your
vehicle.
Check all connections and verify that child seat is secure.
10
The child seat is secure when it cannot be moved front-to-back or side-to-*
side more than 1” (2.5 cm) at the belt path. If the child seat is not secure,
repeat the installation procedure or use a different seating location.
LATCH short path
Harness Mode: Installing Your Child Seat Harness Mode: Installing Your Child Seat