Owner`s manual

26
27
Harness Mode
Harness Mode
Lap-Shoulder Belt – Short
Path
Checklist for proper installation
Does your vehicle:
Have a seat belt that can be locked? 9
Check your vehicle owner’s manual *
to determine what type of vehicle
belt you have and how it can be
locked for use with child seats.
Have a top tether anchor? 9
Always use the Versa-Tether for children weighing 65 – 80 lbs (29.5 – 36.3 kg). *
Britax recommends that the Versa-Tether be used at all times. Using the tether
will improve the stability of the child seat and reduce the risk of injury. Check
your vehicle owner’s manual for tether anchor locations.
Pull the vehicle belt out and route 5
the belt through the first belt slot,
under the cover and through the
second belt slot.
If the vehicle has a tether anchor for
1
the chosen seating position, then
remove the Versa-Tether from the
storage clip.
Loosen the tether and place it up
2
and over the child seat back.
Rotate the recline block to harness
3
position.
Place the child seat on the vehicle
4
seat.
Verify that the belt is not twisted
6
and then buckle.
Push the child seat firmly into the
7
vehicle seat while removing all slack
from the lap portion, then shoulder
portion of the vehicle belt.
Ensure that the vehicle belt *
is locked as directed by your
vehicle owner’s manual.
Attach and tighten the Versa-
8
Tether.
IMPORTANT: Ensure any excess
Versa-Tether
®
webbing is contained
within your vehicle.
Lap-shoulder belt short path
Verify that the vehicle belt is tight and the child seat is secure.9
The child seat is secure when it cannot be moved front-to-back or *
side-to-side more than 1” (2.5 cm.) at the belt path. If the child
seat is not secure, repeat the installation procedure or use a different
seating location.
Harness Mode: Installing Your Child Seat Harness Mode: Installing Your Child Seat