Owner`s manual

30
31
If the vehicle has a tether anchor 1
for the chosen seating position,
then remove the Versa-Tether
from the storage clip.
Harness Mode
Harness Mode
Lap Belt – Short Path Only
Checklist for proper installation
Does your vehicle:
Have a seat belt that can be locked? 9
Check your vehicle owner’s *
manual to determine what type
of vehicle belt you have and how
it can be locked for use with child
seats.
Have a top tether anchor? 9
Always use the Versa-Tether for children weighing 65 – 80 lbs (29.5 – 36.3 *
kg). Britax recommends that the Versa-Tether be used at all times. Using the tether
will improve the stability of the child seat and reduce the risk of injury. Check your
vehicle owner’s manual for tether anchor locations.
Loosen the tether and place it up 2
and over the child seat back.
Rotate the recline block to harness
3
position.
Place the child seat on the vehicle
4
seat.
Pull the vehicle belt out and route
5
the belt through the first belt slot,
under the cover and through the
second belt slot.
Lap belt short path
Verify that the belt is not twisted 6
and buckle.
Push the child seat firmly into the 7
vehicle seat while pulling the lap
belt webbing through the belt slot
to remove all slack.
Ensure that the vehicle belt *
is locked as directed by your
vehicle owner’s manual.
Attach and tighten the Versa-
8
Tether.
IMPORTANT: Ensure any excess
Versa-Tether
®
webbing is contained
within your vehicle.
Verify that the vehicle belt is tight and the child seat is secure.
9
The child seat is secure when it cannot be moved front-to-back or *
side-to-side more than 1” (2.5 cm.) at the belt path. If the child
seat is not secure, repeat the installation procedure or use a different
seating location.
Harness Mode: Installing Your Child Seat Harness Mode: Installing Your Child Seat