Owner`s manual

32
33
This seat can be used in booster mode with children who stand 42”
– 60” (106.7 – 152.4 cm) in height and weigh more than 40 lbs
(11.3 kg). Britax recommends using harness mode to 80 lbs (36.3
kg) and using booster mode only after the child outgrows harness
mode or at least meets all of the fit requirements listed on page 5
(usually around age 4).
Switching Between Modes
Harness to Booster Mode
To remove the harness and buckle:
On the bottom of the seat, slide 5
the metal retainer of one harness
strap up or down to release it
from the child seat shell, then turn
the metal retainer so it will slide
through the slot in the child seat
shell.
Pull the harness webbing tight *
from the other side before
pulling the retainer through.
Loosen the harness by lifting the 1
harness adjuster release lever
located on the front of the child
seat while pulling BOTH harness
straps forward.
Unhook both harness straps from
2
the yoke.
Do not remove the HUGS™ *
pads or chest clip.
Store the yoke on the belt shield.
3
Pull the shoulder straps of the 4
harness from the slots.
Buckle the harness and store all
7
parts in a safe place.
Pull the retainer all the way
6
through to the top of the seat to
remove the harness strap.
Repeat the process for the *
remaining harness strap.
Remove the harness buckle *
strap (see page 10 for buckle
strap removal instructions).
Remove the screw from the head 8
restraint adjuster and store in a safe
place. The screw will be needed to
convert back to harness mode.
Harness Mode: Installing Your Child Seat Harness Mode: Installing Your Child Seat
Harness Mode
Harness Mode
1. Lift lever
2. Pull
BOTH
harness
straps