Owner`s manual

34
35
Booster to Harness Mode
To replace the harness and buckle:
Turn the metal retainer of one harness 6
strap so it will slide through the slot.
Ensure that the harness strap is *
not twisted.
Locate the harness assembly.1
Ensure that harness slots in cover, 3
head restraint and harness adjuster are
aligned. Replace the screw to lock the
head restraint adjuster.
Pull on the buckle to ensure the retainer 5
lies flat against the shell. Verify that the
button faces out.
Seat models vary. You may have *
to slide the buckle retainer back
into place on the bottom of
the child seat to hold it in place
against the child seat shell. See
page 11.
Pull the retainer to the bottom of the 7
child seat shell, then slide the retainer
up or down back into place to hold it
against the child seat shell.
Pull the harness strap to ensure the *
retainer lies flat against the shell.
Ensure that the chest clip faces out.*
Connect the harness strap to the yoke.
9
Repeat steps 5 through 8 for the remaining harness strap.10
Insert the top through the harness slot 8
and harness adjuster to the back of
the seat.
Once the harness has been
11
connected ensure the chest
clip faces out, the straps
are not twisted, and are
securely fitted onto the
harness yoke.
From the top of the child seat, turn the 4
metal retainer of the buckle strap so it
will slide through the slot.
Choose the slot that is closest to, *
but not under your child.
Move the head restraint to the lowest 2
position. Move the harness adjuster to
the highest position.
Harness Mode: Installing Your Child Seat Harness Mode: Installing Your Child Seat
Harness Mode
Harness Mode