Owner`s manual

38
39
Lap-Shoulder Belt
Securing Your Child
Booster Mode
Ensure that the recline block is in 1
booster position.
Place the child seat on the vehicle
2
seat.
Use the vehicle’s lap-shoulder 3
belt to secure your child.
WARNING:
Harness Mode
Never route the vehicle belt over the child when using this child seat •
in harness mode.
Adjust the belts provided with this child seat so they fit snugly •
around your child. A snug strap should not allow any slack. It lies in a
relatively straight line without sagging. It does not press on the child’s
flesh or push the child’s body into an unnatural position.
The HUGS™ chest pads must be used at all times.•
Adjust the harness to fit the clothes the child is wearing. Remove •
bulky coats and/or jackets before putting the child in the child seat.
Verify that the child seat is secure and the harness is properly adjusted •
around the child each time the child seat is used.
Harness Mode
IMPORTANT: Before securing your child in the child seat, always check the
seat area for debris and remove it to prevent interference with the harness
adjuster mechanism.
Loosen the harness by lifting the 1
harness adjuster release lever
located on the front of the child
seat while pulling BOTH harness
straps forward.
Open the chest clip.
2
Press tabs1
Pull apart2
Tighten the Versa-Tether.7 Use the vehicle’s lap-shoulder 8
belt to secure your child.
Harness ModeHarness Mode
WARNING: Always secure this child seat in your vehicle when
unoccupied by using LATCH or the lap-shoulder belt.
Booster Mode: Positioning Your Child Seat
Recline
block
1. Lift lever
2. Pull
BOTH
harness
straps