Instruction manual

A Position the left and
right guards beside
the frame as shown.
B Fit each guard onto
the moulding at the
base of the leg tubes.
Push down until they
lock into position.
C Pull on each guard
in the direction shown,
to make sure they are
locked on correctly.
A To fit the rear
wheels, align the wheel
axle/rod with the hole in
the wheel moulding.
Press in and hold the
central button, then push
the rear wheel fully into
the wheel moulding.
B Release the central
button, then pull on the
rear wheel to make sure
it is locked on. Repeat
steps A & B to fit the
other rear wheel.
C To release the rear
wheels, press in and
hold the central button.
Then slide the wheel out
and remove. Repeat for
the other side.
1.4 FIT & REMOVE THE WHEEL GUARDS
1.5 REAR WHEEL FITTING & REMOVAL
14