Use and Care Manual

9. DUCT CONNECTION

VERTICALLY DUCTED INSTALLATION:

Slide a 6” round metal duct section over the adapter/damper on the hood up to the roof

cap. Use metal foil duct tape to seal the joint.

HORIZONTALLY DUCTED INSTALLATION:

Measure and install 6” round metal ductwork to wall cap and 90° elbow over duct collar

then install the 90° elbow over the adapter/damper on the hood. Use metal foil duct tape

to seal the joints.

NON-DUCTED INSTALLATION:

Remove the damper flaps. Measure the length of 6” round flexible duct (included in the non-

duct kit) required from the top of the hood to the plenum. Slide the 6” round flexible metal

duct over the adapter on the hood. Use metal foil duct tape to seal the joint.