ADA Compliant Statement

ALL OTHER RANGE HOOD SERIES

ACCESS TO RANGE HOOD mAIN HARNESS (CONT’D)

 Remove filters from the hood and set them aside.

 Using a 11/32” nutdriver or socket, remove the lock nut retaining the flange of the right cover plate

(shaded part on illustration at right) to the inner back of hood (see inset). Remove the right cover

plate retaining screws (7 screws), then set the blower cover along with its screws and nut aside.

NOTE: According to range hood models, screw 1 location may vary; it can be on right side of the

+lock nut or on left side (see inset).

HO0275

BACK OF HOOD

LOCk NUT

1 1

ADA CAbLE CONNECTIONS

B Run the ADA cable (GREY cable coming out from the control access

panel) through the provided ferrite, making 2 loops.

HD0956

C Open the provided connection box. Using long nose pliers, break away

2 cable entry notches on the lid (one per side).

HR0156

D Peel off the paper backing on back of connection box base and install

this base on the inner back of the hood, near the power cable knock out,

as shown below. Make sure that the surface is clean before installing the

box.

HD0957

HE0280

F Run one end of the ADA cable through the range hood wire clamp, along

with the power cable, giving enough lenght to make the connection

inside the box. Tighten the wire clamp, then strip the end of the 3 wires

from provided ADA cable.

NOTE: The wire clamp must be suitable for 2 cables.

HE0281

G Strip the end of the 3 wires from GREY cable (the one with ferrite), then

using small UL approved wire nuts (suitable for 22 AWG wires), connect

these wires with ADA cable wires. Connect as follow: WHITE wire with

WHITE wire, BLACK wire with BLACK wire and RED wire with RED wire.

CAUTION

Use exclusively the cable included in this kit.

HR0155

E Cut off and discard the connector at the end of the provided ADA cable.

Use this cable to connect to the remote ADA switch outside the hood

(step

I).

IMPORTANT: leave a cable length of at least 12’’ that protrudes from the

wall (at the same location of the 120 V house wiring.