Installation Guide

3.2 L

OCATING THE UNIT (CONT’D)

3. INSTALLATION (CONT’D)

UNIT HUNG TO WALL BRACKET

Trace a level line on the wall; align the wall bracket (the longer

one) to the line and secure this bracket to the wall using 4 provided

screws (1½” long) and washers, if using the slots on bracket).

VD0379

LEVEL LINE WALL BRACKET

VD0380

Using 1½” long provided screws, assemble both spacers to left and

right back bottom corner of the unit.

WARNING

Ensure the wall bracket is attached to all of the

available studs, not into the drywall alone.

Lift the unit and hang it to the wall bracket. Ensure the bracket

assembled on back of the unit rests on the wall bracket.

VO0271

VO0272

Secure the unit to the wall using one 1½” long provided screw

through the small bracket.

CAUTION

Never use an electric screwdriver or

drill to screw the brackets to the unit;

use a standard screwdriver.

VR0086

VD0392

Using 3/8” long provided screws, mount the other bracket (A) to the

back of the unit; start with the 4 back screws, then 2 screws on top

left and right sides, then use the last center one to assemble the

last small bracket (B).

NOTE: These screws must be hand tightened.