User guide

DOCUMENT ID 994445
Page 4 of 4
collector pipe. Install the muffler to the bracket with the supplied bolt, washers, and locking nut, do not tighten. Install
two (2) springs at each joint and align the muffler to rest flat to the bracket and tighten the mounting bolt.
Re-check all fasteners of system to make sure everything is tightened properly.
RE-INSTALL RADIATOR / OIL COOLER BRACKET
Re-attach the radiator / oil cooler bracket, two (2) “E” clips and washers in the bottom of the radiator and oil cooler.
Insert one (1) bolt to the crankcase to fasten bracket and tighten.
CLEAN SYSTEM OF FINGER PRINTS
With any exhaust system you must clean all finger prints off before starting the motorcycle to insure there will not be
finger prints “burned” into the pipe. Carefully use alcohol, brake clean, etc. to clean the system.
INSTALL BODYWORK AND CHECK CLEARANCE
Replace all bodywork and check clearance. Bodywork must be at lease ¼ of an inch from any part of the exhaust
system.
Brock’s Performance does not warrant burned plastic.
***CAUTION: PAIR BLOCK OFF MUST BE PERFORMED IN ORDER TO
PREVENT PREMATURE EXHAUST FAILURE. PLEASE REFER TO THE PAIR
BLOCK OFF INSTRUCTIONS THAT WERE INCLUDED OR FIND THEM AT
BROCKSPERFORMANCE.COM. FAILURE TO PERFORM THIS MODIFICATION
WILL VOID PRODUCT WARRANTY***
ADDITIONAL
Install the appropriate Power Commander map for your application: BrocksPerformance.com > Map Support
Brocks Performance Products are designed for Closed-Course Race Track use ONLY
.
Brocks Performance Products policies and warranty information: www.BrocksPerformance.com
For additional information: Check our Information Forum
at www.BrocksPerformance.com
E-mail [e-mail]
or call the Order Line 937-912-0054.