Manual

DOCUMENT ID 994406
Page 4 of 4
RE-INSTALL RADIATOR / OIL COOLER BRACKET
Re-attach the radiator / oil cooler bracket, two (2) “E” clips and washers in the bottom of the radiator and oil cooler.
Insert one (1) bolt to the crankcase to fasten bracket and tighten.
CLEAN SYSTEM OF FINGER PRINTS
With any exhaust system you must clean all finger prints off before starting the motorcycle to insure there will not be
finger prints “burned” into the pipe. Carefully use alcohol, brake clean, etc. to clean the system.
INSTALL BODYWORK AND CHECK CLEARANCE
Replace all bodywork and check clearance. Bodywork must be at lease ¼ of an inch from any part of the exhaust
system.
Brock’s Performance does not warrant burned plastic.
ADDITIONAL
Follow the PAIR Block Off Instructions supplied with your purchase and perform the modification. These instructions can
also be found here: www.brocksperformance.com/Instructions/S1000RR/994471.pdf
Install the appropriate Power Commander map for your application: BrocksPerformance.com > Map Support
Brocks Performance Products are designed for Closed-Course Race Track use ONLY
.
Brocks Performance Products policies and warranty information: www.BrocksPerformance.com
For additional information: Check our Information Forum
at www.BrocksPerformance.com
E-mail [e-mail]
or call the Order Line 937-912-0054.