Grill Head Manual
Table Of Contents
- ASSEMBLY INSTRUCTIONS
- P3X SERIES PARTS DIAGRAM
- P4X SERIES PARTS DIAGRAM
- GRILL HEAD HARDWARE PACK - B102155
- UNPACK AND REMOVE LID
- INSERT BURNER HOLD-DOWN BOLT
- WIND DEFLECTOR PLACEMENT
- INSERT CONTROL PANEL
- ATTACH IGNITOR WIRE
- INSTALL BURNER ASSEMBLY
- CONNECT IGNITOR LEADS
- KNOB and battery PLACEMENT
- INSTALL LID STOP
- HANDLE INSTALLATION
- REINSTALL LID
- P3XF(N), P4XF(N) FLARE BUSTERS AND RACKS
- P3SX(N) FLARE BUSTERS,SMOKER SHUTTER AND RACKS
- P3X(N) AND P4X(N) BRIQUETS AND RACKS
- INSTALL WARMING RACK
- PROPANE GAS GRILLS
- CONNECTING NATURAL GAS GRILL
- NATURAL GAS GRILLS
- COMPLETED ASSEMBLY
- OWNER’S MANUAL FOR P3X AND P4X GRILLS
- P3X SERIES PARTS DIAGRAM
B102268-1-0615Page 12
CONTROL
PANEL
CONTROL
PANEL
SHIELD
3/8”
If Side Shelf Accessory was purchased
install at this time. Follow Side Shelf
Note: If Side Shelf Accessory was
purchased install at this time.
Follow Side Shelf instructions.
Ease the Control Shield over the studs on
the Control Panel. Then insert the two
studs through the holes on the front of the
grill. Attach with the two keps nuts.
Remove Plastic Film on label.
INSERT CONTROL PANEL
KEPS NUT,
SS, 10-24
B073967(2)